Command Line Interface - Dell SonicWall SRA 4200 Administrator's Manual

The Command Line Interface (CLI) is a text-only mechanism for interacting with a computer
operating system or software by typing commands to perform specific tasks. It is a critical part
of the deployment of the SRA Virtual Appliance, where basic networking needs to be configured
from the console. The CLI is also supported on the SRA 4600, 4200, 1600, and 1200
appliances.
While the SRA physical appliance products have a default IP address and network
configuration that requires a client's network settings to be reconfigured to connect, the network
settings in an existing VMware virtual environment might conflict with the SRA appliance
defaults. The CLI utility remedies this by allowing basic configuration of the network settings
when deploying the SRA Virtual Appliance.
Note The Dell SonicWALL SRA 6.0 CLI allows configuration of only the X0 interface on the SRA
4600/4200/1600/1200 or SRA Virtual Appliance.
For the SRA physical appliances, console access is achieved by connecting a computer to the
serial port. Use the following settings:
Baud: 115200
•
Data Bits: 8
•
Parity: None
•
Stop Bits: 1
•
For the SRA Virtual Appliance, the following login prompt is displayed after the firmware has
fully booted:
,,,mmbbbbbb11111111111111111111111bbbbbmm,,,
,,,b||PPPPPPP||''''''''''''''''|PPPPPPPPP111111111111bbm,,
''''''
Copyright (c) 2010 SonicWALL, Inc.
SonicWALL SRA Virtual Appliance
sslvpn login:
In the following examples, user input is highlighted in bold to indicate text entered by the user.
To access the CLI, login as admin. The password is the same as the password for the admin
account that is configured on the appliance. The default is password.

Command Line Interface

,,,,,,,,,,,,,,,
'''''PPPP111111111bm,
Appendix F
'''PP1111111bm,
'PP111111b,
|111111:
.1111P|.
,b1PP|'
,,||'''
Command Line Interface | 417