Linksys Wrt54Gs; Watchguard Firebox X Edge - Dell SonicWall SRA 4200 Administrator's Manual

Linksys WRT54GS

The SRA appliance should be configured on the LAN switch of the Linksys wireless router. This
guide assumes that your Linksys is assigned a single WAN IP, via DHCP by the cable ISP and
is using the default LAN IP address scheme of 192.168.1.0/24.
Note Version 2.07.1 Firmware or newer is recommended for this setup.
To configure your Linksys for operation with the SRA appliance, you must forward the SSL
(443) port to the IP address of the SRA appliance.
Login to the Linksys device.
Step 1
Navigate to the Applications & Gaming tab.
Step 2
3.
Application
Port Range Start
Port Range End
Protocol
IP Address
Enable
With the configuration complete, click the Save Settings button on the bottom of the page.
Step 3
The Linksys is now ready for operations with the SRA appliance.

WatchGuard Firebox X Edge

This guide assumes that your WatchGuard Firebox X Gateway is configured with an IP of
192.168.100.1 and your SRA appliance is configured with an IP of 192.168.100.2.
Note The steps below are similar for WatchGuard SOHO6 series firewall.
Enter the following information:
SRA
443
443
TCP
192.168.1.10
Checked
The name for the port forwarded application.
The starting port number used by the application
The ending port number used by the application
The Dell SonicWALL SRA application uses TCP
The IP address assigned to the SRA appliance.
Select the check box to enable the SSL port forward-
ing
Configuring the SRA Appliance with a Third-Party Gateway | 365