Configuring High Availability
High Availability (HA) requires one SRA 4200 or 4600 configured as a primary device and an
identical SRA configured as a backup device. The HA connection between two SRA appliances
is in an Active/Passive state.
The High Availability > Settings page provides the settings for configuring High Availability.
See the following sections for configuration information:
•
•
•
•
•
•
230 | SRA 6.0 Administrator's Guide
"Physical Connectivity" section on page 231
"Preparing for High Availability" section on page 231
"Configuring High Availability Settings" section on page 231
"Enabling Interface Monitoring" section on page 232
"Configuring Network Monitoring Addresses" section on page 232
"Synchronizing Firmware" section on page 233