Dell SonicWall SRA 4200 Administrator's Manual page 126

If you just created a network object, the Edit Network Object screen is displayed as soon as
you clicked Accept.
The Edit Network Object shows the network object name and the service associated with it.
It also contains an address list that displays existing addresses mapped to the network object.
To change the service, select the desired service from the Service drop-down list and then click
Step 2
Update Service. The Service column in the Network Objects table displays the new service,
and the Edit Network Object dialog box remains open. You can click Done if finished.
To add or edit Type and Address values for this Network Object, click Add. The Define Object
Step 3
Address page is displayed. See
When finished adding addresses, click Done in the Edit Network Object screen.
Step 4
The Network > Network Objects page is displayed with the new network object in the Network
Step 5
Objects list.
If the object is not fully defined with at least one IP address or network range, the status
Step 6
Incomplete will display. Click the Incomplete link or the Configure icon to edit the network
object again, and then click Add to add Type and Address values for this network object. The
Define Object Address page is displayed. See
Note Policies cannot be created for incomplete network objects.
Defining an Object Address
In the Define Object Address page, click on the Object Type drop-down list and select an
Step 1
object type. The four object types are:
126 | SRA 6.0 Administrator's Guide
IP Address - A single IP address.
–
Network Address - A range of IP addresses, defined by a starting address and a
–
subnet mask.
"Defining an Object Address" on page
"Defining an Object Address" on page
126.
126.