Dell SonicWall SRA 4200 Administrator's Manual page 202

Configuring Group NetExtender Routes
To configure NetExtender client routes:
To add a NetExtender client route that will only be added to this user, click the Nx Routes tab
Step 1
in the Edit User Settings window.
To add a NetExtender client route that will only be added to users in this group, click the Add
Step 2
Client Route button.
Type the IPv4 or IPv6 address of the trusted network to which you would like to provide access
Step 3
with NetExtender in the Destination Network field.
For an IPv4 route, type the subnet mask in the Subnet Mask/Prefix field. For an IPv6 route,
Step 4
type the prefix in the Subnet Mask/Prefix field.
Click Add. Repeat this procedure for all necessary routes.
Step 5
Select Enabled from the Tunnel All Mode drop-down list to force all traffic for this user—
Step 6
including traffic destined to the remote users' local network—over the SRA NetExtender tunnel.
To also add the global NetExtender client routes (which are configured on NetExtender >
Step 7
Client Routes page) to users in this group, select the Add Global NetExtender Client Routes
check box.
Click Accept.
Step 8
202 | SRA 6.0 Administrator's Guide