End Point Control Overview - Dell SonicWall SRA 4200 Administrator's Manual

Refer to the
Tip
Note These SMS email formats are for reference only. These email formats are subject to change
and may vary. You may need additional service or information from your provider before
using SMS. Contact the SMS provider directly to verify these formats and for further
information on SMS services, options, and capabilities.
To configure the SRA appliance to send one-time passwords to an SMS email address, follow
the procedure described in the
user's SMS address in the E-mail address field.
Verifying Administrator One Time Password Configuration
To verify that an individual user account has been enabled to use the One Time Password
feature, login to the SRA Virtual Office user interface using the credentials for that account.
If you are able to successfully login to Virtual Office, you have correctly used the One Time
Password feature.
If you cannot login using One Time Password, verify the following:
•
•
•
•

End Point Control Overview

This section provides an introduction to the End Point Control feature. This section contains
the following topics:
•
•
•
•
What is End Point Control?
In traditional VPN solutions, accessing your network from an untrusted site like an employee-
owned computer or a kiosk at an airport or hotel increases the risk to your network resources.
The SRA appliance includes End Point Control (EPC), a default service available on all SRA
series appliances. EPC provides secure access from any Web-enabled system, including
devices in untrusted environments. The SRA appliance supports.
48 | SRA 6.0 Administrator's Guide
"" section on page 421
Are you able to login without being prompted to check your email for One-time Password?
The user account has not been enabled to use the One-time Password feature.
Is the email address correct? If the email address for the user account has been entered
incorrectly, login to the management interface to correct the email address.
Is there no email with a one-time password? Wait a few minutes and refresh your email
inbox. Check your spam filter. If there is no email after several minutes, try to login again
to generate a new one-time password.
Have you accurately typed the one-time password in the correct field? Re-type or copy and
paste the one-time password within the time allotted by the user's timeout policy as set in
the Log > Settings page.
"What is End Point Control?" on page 48
"Benefits of End Point Control" section on page 49
"How Does End Point Control Work?" section on page 49
"Configuring End Point Control" section on page 49
for a more detailed list of SMS email formats.
"Editing User Settings" section on page 291, and enter the