Mounting Safety And Warning Guidelines - Christie Q Series Installation And Setup Manual

Notice. If not avoided, the following could result in property damage.
• Always place the lens cap onto the lens when moving the projector to avoid scratching the lens.
• Remove the lens cap before turning the product on to avoid damaging the lens.
• Only use cleaning solutions recommended by Christie. All other cleaning solutions may cause
product damage and will void the warranty.
• Do not reuse lens tissues.
• Always use a lens plug when installing or moving the product. This prevents contaminants from
entering the product.
• Do not place objects over the lens while the projector is on.

Mounting safety and warning guidelines

Read all safety and warning guidelines before installing the mounting brackets.
Warning! If not avoided, the following could result in death or serious injury.
• All procedures must be performed by Christie qualified technicians.
• TIP HAZARD! Do not place, hang, or apply weight to the device or any of its components.
Caution! If not avoided, the following could result in minor or moderate injury.
• SHOCK HAZARD! Disconnect the product from AC before moving, servicing, cleaning, removing
components, or opening any enclosure.
• Do not install on a structure susceptible to vibration, movement, or change due to impact.
Notice. If not avoided, the following could result in property damage.
• SHOCK HAZARD! All harnessing must be properly routed and secured as originally installed,
especially in high voltage areas.
• FIRE HAZARD! Do not use a power cord, harness, or cable that appears damaged.
Optional Lenses Q Series Installation and Setup Manual
020-102550-01 Rev. 1 (04-2017)
Copyright 2017 Christie Digital Systems USA Inc. All rights reserved.
©
Introduction
5