KEP MMI-1500 Installation & Operation Manual page 87

Dialog asking for Project password on upload.
7.9.3.2 User Security: Activate User security by selecting the System Parameters|Security Tab, and Security Control
option.
Once user security is enabled, all base
windows have a security level assigned to
them. A window can only be accessed if the
security level or higher for that window is
active.
Note: The only exception to this is the Startup window. That window comes up when the unit is started. The security
level is still at zero on startup, even if the startup window is set at a higher level. In this case, once the startup window
is closed, a password level change is required to get back to it.
Note: The HMI only checks the security level when the user tries to change base windows with a "Change window"
Function Key.
Note: Security does not inhibit Function Popup Windows, Direct Windows, Indirect Windows, and PLC Control Window
Change parts.
Fill in the Password Level fields to set the passwords for each level.
Level Window Setting
Lowest
0
Middle
1
Highest
2
Window Setting Dialog showing the
Security Level setting.
Description
All have access to these windows regardless of the password.
No Level 1 or 2 windows can be accessed from this level.
Allows access to level 1 and level 0 windows. No Level 2
windows can be accessed from this level.
Allows access all levels
79
Typical Use
Operators and general
personnel
Setup and maintenance
personnel
Supervisors