KEP MMI-1500 Installation & Operation Manual page 268

16.28.3.4 Wiring for cable connections using MITSUBISHI RS485BD Module with RS485 Screw Terminal
ports.
KEP Part#: (Not Available) (D-Sub 9 Female Plug to Flying Leads Cable)
HMI PLC[RS-485]
2 RxD+
1 RxD-
4 TxD+
3 TxD-
5 GND
Note: Graphic representation may not reflect the actual appearance of the finished cable.
16.28.4 Device address
Bit/Word Type Address Format
B X
B Y
B M
B T
B C
B SM
B D(bit)
W TV
W CV
W CV2
W D
W SD
Note: The PLC's memory range may vary within the range supported by the driver. Use appropriate addresses.
Connect to MITSUBISHI RS485BD Module RS422 Port
1 SDB-
2 SDA+
3 RDB-
4 RDA+
5 GND
Shield Earth Ground
Range
ooo ooo: 0 ~ 377
ooo ooo: 0 ~ 377
dddd dddd: 0 ~ 7999
ddd ddd: 0 ~ 255
ddd ddd: 0 ~ 255
dddd dddd: 8000 ~ 9999
ddddbb dddd: 0 ~ 7999
bb: 00~15
ddd ddd: 0 ~ 255
ddd ddd: 0 ~ 199
ddd ddd: 200 ~ 255
dddd dddd: 0 ~ 7999
dddd dddd: 8000 ~ 9999
Input Relays (I). Addresses are in Octal
Output Relays (O). Addresses are in Octal
Internal Relays
Timer Control Relays
Counter Control Relays
Special Relays
Note: MITSUBISHI FX2n D9bit [PDS] driver only
Data Word Relays
Note: MITSUBISHI FX2n D9bit [PDS] driver only
Single Word Timer
Single Word Counter
Double Word Counter
Data Words
Special Data Words
Note: MITSUBISHI FX2n D9bit [PDS] driver only
260
Notes