KEP MMI-1500 Installation & Operation Manual page 289

16.35.3.2 Wiring for cable connections using OMRON CJ1W-SCU41 communication module with RS-422
Host Link D-Sub 9 Female Plug ports.
KEP Part#: (Not Available) (D-Sub 9 Female Plug to D-Sub 9 Male Socket Cable)
HMI PLC[RS-485]
1 RXD-
2 RXD+
3 TXD-
4 TXD+
Wiring for cable connections using OMRON CJ1W-CJ1W-C1F11 communication module with RS-
16.35.3.3
422 Host Link screw terminal ports.
KEP Part#: (Not Available) (D-Sub 9 Female Plug to flying leads)
HMI PLC[RS-485]
1 RXD-
2 RXD+
3 TXD-
4 TXD+
5 GND
Note: Graphic representation may not reflect the actual appearance of the finished cable.
16.35.4 Device address
Bit/Word Type Address Format
B CIO
B HR
B AR
B LR
B T(Status)
B C(Status) dddd
W T(Value)
W C(Value)
W DM
W EM
W CIOW
W HRW
W ARW
W LRW
Note: The Controller's memory range may vary within the range supported by the driver. Use appropriate addresses.
Connect to OMRON CJ1W-SCU41 RS-422 Host Link port
1 SDA
2 SDB
6 RDA
8 RDB
7 Shield Earth Ground
Connect to OMRON CJ1W-CJ1W-C1F11 RS-422 Host Link port
3 SDA-
4 SDB+
1 RDA-
2 RDB+
7 Shield Earth Ground
ddddbb dddd: 0~6143 bb: 00~15
dddbb ddd: 0~511 bb: 00~15
dddbb ddd: 0~959 bb: 00~15
dddbb ddd: 0~199 bb: 00~15
dddd dddd: 0~2047
dddd: 0~2047
dddd dddd: 0~2047
ddd ddd: 0~2047
dddd dddd: 0~6143
dddd dddd: 0~9999
dddd dddd: 0~9999
dddd ddd: 0~511
dddd ddd: 0~959
dddd ddd: 0~199
Range
Always use 2 digits for bit designation
Always use 2 digits for bit designation
Always use 2 digits for bit designation
Always use 2 digits for bit designation
Timer Completion coil status
Counter Completion coil status
Timer actual time value
Counter actual count
Data Memory
Extended Memory
Channel I/O as words
Holding Relay as words
Auxiliary Relay as words
LR as words
281
Notes