KEP MMI-1500 Installation & Operation Manual page 4

Safety Instructions
Overview
This section states the safety instructions which must be followed when installing, operating and servicing the
MMI. If neglected, physical injury and death may follow, or damage may occur to controller and related
equipment. The material in this chapter must be studied before attempting any work on, or with, the unit.
Warnings and Notes
This manual distinguishes safety instructions. Warnings are used to inform of conditions, which can, lead if
proper steps are not taken, to a serious fault condition, physical injury or death. Notes are used when the
reader is required to pay special attention or when there is additional information available on the subject.
Notes are less crucial than warnings, but should not be disregarded. Readers are notified of the need for
special attention or additional in formation available on the subject with the following symbols:
Warnings
Readers are informed of situations that can result in serious physical injury and/or serious damage to
equipment with the symbol shown to the left. A Warning symbol indicates that the reader should pay
special attention to the accompanying text. Take precautionary steps to insure that the installation
complies with warnings before continuing. Warnings include hazardous conditions that could cause
personal injury or equipment damage if care is not taken. The text next to this symbol describes ways to
avoid the danger.
Warnings
Dangerous Voltage Warnings: Warns of situations in which high voltage can cause physical injury and
or damage equipment.
General warning: Warns of situations, which can cause physical injury and or damage equipment by
means other than electrical.
Electrostatic Discharge Warning: Warns of situations in which an electrostatic discharge can damage
equipment.
CAUTION!
Caution: Aims to draw special attention to the text. Be sure to understand the implications of the text
before proceeding.
Note: gives additional information or points out more information available on the subject.
Note:
This manual is designed to provide the necessary information for trouble-free installation and operation of
HMI Touchscreens. Additional help is available when accessing the help functions in the EasyBuilder
software. If further assistance is needed, please call KEP at 1-800-631-2165 or visit our web site at
www.kep.com.
IMPORTANT
Backup project files (*.epj) as needed to insure the ability to modify a project in
the future!
NOTE!
APPLICATIONS ASSISTANCE
iv