KEP MMI-1500 Installation & Operation Manual page 159

Note: Attribute Functions
No. of states: Up to 32 different states can be assigned to the Moving Shape Part. For example: If the moving shape was a
needle pointer, you could have it change to different states that display it as different colors.
Style: Position is controlled by the Read Address Device as shown in the table below.
Control by PLC
Read Address
Read Address+1
Read Address+2
When scaling is used, scaling is performed as follows:
Display value = (reading value – Input low) * (Scaling high – Scaling low)
(Input high – Input low)
When reverse scaling is used, scaling is performed as follows:
Display value = (Input high – reading value) * (Scaling high – Scaling low)
(Input high – Input low)
Possible selections:
Selection
X axis only
Y axis only
X & Y axis
X axis w/ scaling
Y axis w/ scaling
X axis w/ reverse scaling
Y axis w/ reverse scaling
X axis (all types)
Shape or Bitmap State
X position
Not Used
Description
Shape moves Left (0) to Right (Max. screen resolution 320 or 640)
Shape moves Top (0) to Bottom (Max. screen resolution 240 or 480)
Shape moves Top Left (0) to Bottom Right (Max. screen resolution 240, 320 or 480, 640)
Shape moves Left (0) to Right (Max. scaled screen resolution 320 or 640)
Shape moves Top (0) to Bottom (Max. scaled screen resolution 240 or 480)
Shape moves Right (0) to Left (Max. scaled screen resolution 320 or 640)
Shape moves Bottom (0) to Top (Max. scaled screen resolution 240 or 480)
Y axis (all types)
Shape or Bitmap State
Y position
Not Used
151
X & Y axis
Shape or Bitmap State
X position
Y position