Return To Previous; Change Common Window - KEP MMI-1500 Installation & Operation Manual

13.7.4 Return to Previous

This function terminates the existing window and
recalls the last active window.
For example: If window 21 was replaced by window 32, and window 32 has a Function defined as Return to Previous, then,
when it is pressed, window 32 is terminated and window 21 is displayed.
Note: Indirect, Direct and Popup windows cannot be recalled.

13.7.5 Change Common Window

If the function key is set as "Change Common
Window", when the touch area is pressed
(activated), the current common window display
terminates. The new common window designated
by Window No. is displayed. Any full screen base window can be used as a replacement for the default Common window
(Window 6).
Note: Be sure to select a valid window number. Project cannot compile if Window No. is not defined.
13.7.6 Popup Window
If the function key is set as "Popup Window",
when the touch area is pressed (activated), the
window designated by Window No is displayed
over top of the base window. The existing
window(s) are not terminated.
Window 10
Note: A window assigned to a function key as a Popup window and also assigned to a Direct or Indirect Window part
on the same screen is not displayed when the Popup key is pressed. The Direct/Indirect Window control disables the
function key. In addition, Indirect/Direct Windows disable Function key Popup keys placed in them.
13.7.7 Close Window
A Close Window function key terminates the
window it is placed in when pressed. This is the
method for operators to close Popup Windows.
Caution: This type of function key can also be placed on Base windows. Closing all windows
may leave the operator with no way to proceed! Be sure to have a way for the operator or
PLC to call up a window when this happens.
Window 10
Window 100
'Popup' Window 100
137