KEP MMI-1500 Installation & Operation Manual page 134

Set Style Description of action
Design Tip: Use the following on window open/close Set Bit parts to initiate actions in the HMI and Controller. For
example you might want to turn a bit on/off in the controller when the operator enters/exits the setup window. The
Controller would then suspend operations pending the change in setup.
When the window containing this Set Bit Part is opened, the designated Device address is
Set ON at window
turned ON.
open
When the window containing this Set Bit Part is opened, the designated Device address is
Set OFF at window
turned OFF.
open
When the window containing this Set Bit Part is closed, the designated Device address is
Set ON at window
turned ON.
close
When the window containing this Set Bit Part is closed, the designated Device address is
Set OFF at window
turned OFF.
close
Design Tip: Use the following on window maximize/minimize Set Bit Parts to initiate actions depending a window
state.
When the window containing this Set Bit Part is maximized, the designated Device
Set ON at window
address is turned ON.
maximized
When the window containing this Set Bit Part is maximized, the designated Device
Set OFF at window
address is turned OFF.
maximized
When the window containing this Set Bit Part is minimized, the designated Device address
Set ON at window
is turned ON.
minimized
When the window containing this Set Bit Part is minimized, the designated Device address
Set OFF at window
is turned OFF.
minimized
Design Tip: Use the following on backlight Set Bit Parts to initiate actions that depend on the screen being active.
For example: A Set Bit part of this type might signal a process to go to "sleep mode" because no one is monitoring
it.
When the backlight is turned off, the designated Device address is turned ON.
Set ON at backlight
off
When the backlight is turned off, the designated Device address is turned OFF.
Set OFF at backlight
off
Design Tip: Use the following on data entry Set Bit Parts to initiate actions that depend on valid data. For example:
Use a Set ON at enter success to trigger the controller to advance the HMI to the next window.
When a function key with the ENT attribute is pressed in response to a Numeric Input or
Set ON at enter
ASCII Input part and the attempt to write the data succeeds, the designated Device
success
address is turned ON.
When a function key with the ENT attribute is pressed in response to a Numeric Input or
Set OFF at enter
ASCII Input part and the attempt to write the data fails, the designated Device address is
success
turned OFF.
126