KEP MMI-1500 Installation & Operation Manual page 137

Set Style Parameters
Design Tip: Use the Periodical styles along with the Animation
and Move parts to make window animations.
Set Style Parameters
Periodical Inc. value
Upper limit
JOG++
Break time
Maximum:
32767
Periodical Dec. value
JOG-- Bottom limit
Break time
Minimum:
-32768
Periodical Inc. value
bounce Upper limit
Break time
Note: Interval times in actual operation may vary from specified. Do not use HMI intervals for critical timing.
Step up Low limit
High limit
Break time
Description
Description
This Attribute becomes active
automatically when the window is
active. The Inc. value is added to
the designated word, if the result
is not larger than Upper limit.
Once the upper limit is reached or
exceeded, the value returns to
zero and incrementing begins
again. The Break time is the time
between increments.
This Attribute becomes active
automatically when the window is
active. The Dec. value is
subtracted from the designated
word, if the result is not less than
Bottom limit. Once the bottom
limit is reached or exceeded,
decrementing stops. The Break
time is the time between
decrements.
This Attribute becomes active
automatically when the window is
active. The Inc. value is added to
the value of the designated word
at regular intervals as specified by
the Break time until the Upper
limit is reached. Then the Inc
value is subtracted from the
designated word until zero is
reached. This cycle is repeated
until the window becomes
inactive.
This Attribute becomes active
automatically when the window is
active. The value is incremented
by 1 at regular intervals as
specified by the Break time until
the High limit is reached. Then
the value is reset to the Low
limit. This cycle is repeated until
the window becomes inactive.
Design Tip: Use the Step styles
along with the Move part to
animate graphics within a fixed
pixel boundary.
129