KEP MMI-1500 Installation & Operation Manual page 216

16.2.4 Device address
Bit/Word Type Address
B I1
B O0
B B3, 10~13
B Bfn*
B NfnBit*
W N7, 10~15
W F8 (N8)
W T4 SV,PV
W C5 SV,PV
W Nfn*
Note: Attempting to access a device that is not defined in PLC memory causes the
HMI to display the "No response" error message.
Note: The PLC's memory range may vary within the range supported by the driver. Use appropriate addresses.
Note: *The NfnBit, Bfn, and Nfn device types allow access to any data file (fff) and element (nnn) in memory. fff specifies the
data file 000-254, and nnn specifies the element number 000-254. For example, to specify Integer data file 15, element 7
(N15:7), select Nfn as the device type and enter 015007 as the Device address.
Note: See Note 16.3.5 for more information on formatting Device Addresses.
Range
Format
dddbb ddd: 000~254 bb: 00~15
dddbb ddd: 000~254 bb: 00~15
dddbb ddd: 000~254 bb: 00~15
fffdddbb fff: 7, 10~254 ddd: 000~254
bb:00~15
fffdddbb fff: 7, 10~254 ddd: 000~254
bb:00~15
ddd ddd: 000~254
ddd ddd: 000~254
ddd ddd: 000~254
ddd ddd: 000~254
fffddd fff: 7, 10~254 ddd: 000~254
See Note 16.2.5 after this section
See Note 16.2.5 after this section
File number is fixed, specify both Element and Bit
File, Element and bit must be specified
Both File and Element must be specified
File number is fixed, specify Element
Floating Point words
PV is timer accumulator, SV is preset
PV is counter accumulator, SV is preset
Both File and Element must be specified
208
Notes