KEP MMI-1500 Installation & Operation Manual page 126

12.5 Using Compact Flash to transfer retentive memory
Uploaded retentive memory can be transferred to HMI units with Compact Flash ports. These units accept CompactFlash
memory cards. Data is stored to the CompactFlash
the units retentive memory. This is convenient for sending recipe updates to remote locations and customer sites. It also
allows the data to be transferred to the unit without the need of a portable PC or other external equipment.
A project must be in the HMI that shows the status of LB9360, displays the value in LW9136 and has a SetBit part to
activate LB9361.
12.5.1 Transferring data to CompactFlash
Copy the previously uploaded *.rcp file to the CompactFlash
PC is needed to do this. CompactFlash
Note: The CompactFlash
card a volume label.
12.5.2 Transferring data from CompactFlash
1. Remove the CompactFlash
located.
2. Insert the CompactFlash
Check that LB9360 changes status from OFF to ON.
3. Force LB9361 to ON. Check that LW9136 changes from 0 to 1. Once the download is complete, LW9136 changes
to 2. This indicates a successful transfer.
Note: If a 3 is displayed in LW9136 then the download has failed. You may need to repeat the process making sure
all steps are followed.
TM
interfaces are available in most stores that sell computer hardware.
TM
memory card may be formatted as FAT16 or FAT32, do not give the CompactFlash
TM
card from the CompactFlash
TM
card into the units CompactFlash
TM
memory cards, transported to the unit and inserted, then transferred to
TM
memory
TM
memory card. A CompactFlash
TM
to retentive memory
TM
interface and transport it to the site where the HMI is
TM
slot.
118
TM
interface attached to your
TM
memory
TM