KEP MMI-1500 Installation & Operation Manual page 214

16.1.4 Device address
Bit/Word Type Address
Format
B I1
B O0
B B3, 10~13
B Bfn* fffdddbb
B NfnBit* fffdddbb
W N7, 10~15
W Nfn*
W F8 (N8)
W Ffn*
W T4 SV,PV
W C5 SV,PV
Note: Attempting to access a device that is not defined in PLC memory causes the
HMI to display the "PLC no response" error message.
Note: The PLC's memory range may vary within the range supported by the driver. Use appropriate addresses.
Note: *The NfnBit, Bfn, Nfn and Ffn device types allow access to any data file (fff) and element (nnn) in memory. fff specifies
the data file 000-254, and nnn specifies the element number 000-254. For example, to specify Integer data file 15, element 7
(N15:7), select Nfn as the device type and enter 015007 as the Device address.
See Note 16.3.5 for more information on formatting Device Addresses.
Range
dddbb ddd: 000~254 bb: 00~15
dddbb ddd: 000~254 bb: 00~15
dddbb ddd: 000~254 bb: 00~15
fff: 7, 10~254 ddd: 000~254
bb:00~15
fff: 7, 10~254 ddd: 000~254
bb:00~15
ddd ddd: 000~254
fffddd fff: 7, 10~254 ddd: 000~254
ddd ddd: 000~255
fffddd fff: 7, 10~254 ddd: 000~254
ddd ddd: 000~254
ddd ddd: 000~254
See Note on AB I/O addressing after section 14.2.
See Note on ABI/O addressing after section 14.2.
File number is fixed, specify both Element and Bit
File, Element and bit must be specified
Both File and Element must be specified
File number is fixed, specify Element
Both File and Element must be specified
Floating Point words
Both File and Element must be specified
PV is timer accumulator, SV is preset
PV is counter accumulator, SV is preset
206
Notes