KEP MMI-1500 Installation & Operation Manual page 244

16.16.4 Device address
Bit/Word Type
B End_Command
B Relay(bit)
W DM
W TM
W Relay
W Timer_Contact
W Timer_Current
W Timer_Preset
W Counter_Contact
W Counter_Current
W Counter_Preset
The PLC's memory range may vary within the range supported by the driver. Use appropriate addresses.
Address Format Range
d d: 0
dddbb0 dddbb:0~19999
bb: 00~15
dddd dddd: 0~1999
dd dd: 0~99
ddddd ddd: 0~19999
ddd ddd: 0~999
ddd ddd: 0~999
ddd ddd: 0~999
ddd ddd: 0~999
ddd ddd: 0~999
ddd ddd: 0~999
The End_Command is used to suspend or enable
communications to the PLC. Communications are
automatically started when the HMI is powered up.
Must add "0" after the address
Data Memory
Temporary Memory
Relays
Timer Bits
Timer Accumulator
Timer Preset
Counter Bits
Counter Accumulator
Counter Preset
236
Notes