Table of Contents
Advertisement
Solution Ultima 880
Introduction
Thank you for choosing the Solution control panel for your installation. We are sure that you will
find this system extremely flexible, reliable and easy to use. The quick reference guide is supplied
with the system to provide users with enough basic information to wire, configure and program the
system. Due to the systems many programmable features and options, we suggest that you obtain
the complete installation manual that provides detailed information on system options and functions
and programming methods.
Programming
The programming options of the system are stored in a non-volatile EPROM. This memory will
hold all information during a total power loss and can be changed as many times as required.
In general, the entire programming sequence will consist of entering a location number and then
change the data as required.
Programming the system can be via the following methods:
•
Codepad
•
Hand Held Programmer
•
Alarm Link Software
Programming Using A Codepad
The system needs to be disarmed (with no active alarm) to program the system. If there is an
active alarm or the system is armed, enter the code for User 1 (Default = 2580) followed by the #
key (User Code 1 is factory default as the Master Code).
To enter installer's programming mode, enter the installer code (Default = 1234) followed by the #
key. Two beeps will be heard and both the STAY and AWAY indicators will flash simultaneously to
indicate that you have entered programming mode. The codepad indicators will display the current
data programmed in LOCATION 000 (First location of the Primary Telephone Number).
To move to another programming location, enter the location number followed by the # key. The
data in the new location will now be displayed via the codepad indicators (eg. If you entered 34#,
the system will jump you to LOCATION 034, the beginning of the Subscriber ID Number For
Receiver 1).
To move to the next location, press the # key. This will step you to the next location. The data in
the next location will now be displayed via the codepad indicators (eg. If you are currently
positioned at LOCATION 034, pressing the # key will take you to LOCATION 035).
To step back one location, press the * key (eg. If you are currently positioned at LOCATION 35,
pressing the * key will take you back to LOCATION 34).
To change data in the current location, enter the new value (0 – 15) followed by the * key. This will
store the new data into the location and leave you at the same location (eg. If you enter the value
14*, both the Zone 4 indicator and the MAINS indicator will display to represent the new data
value).
To move to the next location, press the # key. The data in the next location will now be displayed.
To exit Installer's Programming Mode, enter 960#. Two beeps will be heard and the STAY and
AWAY indicators will no longer display. The system has now returned to the disarmed state and is
now ready for use.
The table below is a quick guide to programming:
Enter Installer's Programming Mode
Exit Installer's Programming Mode
Step To Next Location
Step Back One Location
Program New Data Into Location
Jump To Another Location
Quick Reference Guide
Bosch Security Systems Pty Limited
1234#
960#
#
*
Data + * (Data = 0 – 15)
Location No. + #
3
Advertisement
Table of Contents
