Easy Operation Mode Setting (Easy Setting Mode) - Mitsubishi Electric FR-F720P-0.75K Instruction Manual

Operation panel (FR-DU07)
4.1.3

Easy operation mode setting (easy setting mode)

Setting of Pr. 79 Operation mode selection according to combination of the start command and speed command can
be easily made.
Operation example
Start command by the external signal (STF/STR), frequency command by
Operation
1. Screen at power-ON
The monitor display appears.
2. Press and
3. Turn until
(Refer to the table below for other settings)
* To use
4. Press to set.
REMARKS
is displayed ... Why?
Pr. 79 is not registered in user group with "1" in Pr. 160 User group read selection.
Parameter write is disabled with "1" set in Pr. 77.
is displayed ... Why?
Setting cannot be changed during operation. Turn the start command (
If is pressed before pressing
If the easy setting mode is terminated while Pr.79 = "0 (initial setting)," the operation mode switches between the PU operation
mode and the External operation mode. Check the operation mode.
Reset can be made with
The priorities of the frequency commands when Pr. 79 = "3" are "Multi-speed operation (RL/RM/RH/REX) > PID control (X14) >
terminal 4 analog input (AU) > digital input from the operation panel".
48
for 0.5s.
appears.
Operation Panel Indication
Flickering
Flickering
Flickering
Flickering
as a potentiometer, refer to page 56.
, the easy setting mode is terminated and the display goes back to the monitor display.
.
Operation Method
Start command Frequency command
,
External Analog
(STF, STR) voltage input
External
(STF, STR)
Analog
,
voltage input
Flicker ··· Parameter setting complete!!
The monitor display appears after 3s.
or
.
Display
Flickering
*
*
, STF or STR) OFF.