Parameter Copy And Parameter Verification; Parameter Copy - Mitsubishi Electric FR-F720P-0.75K Instruction Manual

Fr-f700p series
Hide thumbs Also See for FR-F720P-0.75K:
Table of Contents

Advertisement

Parameter copy and parameter verification

5.8 Parameter copy and parameter verification
PCPY Setting
0
1
2
3
REMARKS
· When the copy destination inverter is not the FR-F700(P) series or parameter copy write is performed after parameter copy read is
stopped, "model error (
· Refer to the parameter list on
· When the power is turned OFF or an operation panel is disconnected, etc. during parameter copy write, perform write again or check
the values by parameter verification.
· Initial settings of certain parameters are different for different capacities, so some parameter settings may be automatically changed
when parameter copy is performed from a different-capacity inverter. After performing a parameter copy from a different-capacity
inverter, check the parameter settings. Especially under IPM motor control, check the Pr.80 Motor capacity setting before starting the
operation. (Refer to the parameter list (page 87) for the parameters with different initial settings for different capacities.)
5.8.1

Parameter copy

Parameter settings can be copied to multiple inverters.
1.
Connect the operation panel to the
copy source inverter.
• Connect it during a stop.
2.
Press
setting mode.
3.
Turn
until
appears.
4.
Press
to to read the present set value.
"
"(initial value) appears.
5.
Turn
to change it to
the setting value " ".
6.
Press
to the operation panel.
7.
Connect the operation panel to the
copy source inverter.
8.
After performing steps 2 to 5,
turn
to change it to "
9.
Press
the operation panel to the destination inverter.
10.
When copy is completed,
"
" and "
11.
After writing the parameter values to the copy
destination inverter, always reset the inverter,
e.g. switch power OFF once, before starting operation.
80
Cancel
Copy the source parameters to the operation panel.
Write the parameters copied to the operation panel into the destination inverter.
Verify parameters in the inverter and operation panel. (Refer to page 81.)
)" is displayed.
page 87
and later for availability of parameter copy.
Operation
to choose the parameter
(parameter copy)
to copy the source parameters
".
to write the parameters copied to
" flicker.
Description
About 30s later
Flicker ··· Parameter copy complete!!
Flicker ··· Parameter copy complete!!
Display
The parameter
number read
previously appears.
The frequency flickers
for about 30s
The frequency flickers
for about 30s

Advertisement

Table of Contents
loading

Table of Contents