Panasonic KX-TD816 Installation Manual page 64

2.2.3 Wall Mounting
KX-TD816
Mounting on Wooden Wall
1. Place the templet (included) on the wall
to mark the three screw positions.
Templet
2. Install the three screws (included) into the
wall.
Drive the screw
to this position
3. Hook the main unit on the screw heads.
2-8 Installation
This set is exclusively made for wall mounting only. The wall
where the main unit is to be mounted must be able to support the
weight of the main unit. If screws other than the ones supplied are
used, use the same-sized diameter screws as the enclosed ones.
Wooden
Wall
Mounting on Concrete or Mortar
Wall
1. Place the templet (included) on the wall
to mark the three screw positions.
2. Drill three holes and drive the anchor
plugs (included) with a hammer, flush to
the wall.
To the wall surface
Anchor Plug
3. Install the three screws (included) into
the anchor plugs.
Drive the screw
to this position
4. Hook the main unit on the screw heads.
Concrete Wall
6.4 mm
(1/4 inch)
29 mm
(1 1/8 inch)