4.3
System Programming
Conditions
Feature References
Expansion Unit Type
6.
Keep pressing SELECT until the desired selection is
displayed.
7.
Press STORE.
8.
Press END.
• There are two expansion areas in KX-TD816, areas 1 and 2 from
bottom to top. One 8-Station Line Unit and one 4-CO Line Unit can be
installed.
• There are three expansion areas in each system for KX-TD1232, areas
1, 2 and 3 from bottom to top. Up to two 8-Station Line Units and one
4-CO Line Unit can be installed in each system.
• The out-of-service system is unassignable. In this case, skip the steps 5
through 7 for KX-TD1232.
• In the case of KX-TD1232, if the Slave System only is in operation, the
display shows "Slave" at step 2.
• After changing the setting, to make your setting effective, turn the
Power Switch off and on once. Otherwise the previous setting will be
maintained.
Section 3, Features,
Module Expansion
(contd.)
System Programming
109
4-41