Panasonic KX-TD816 Installation Manual page 292

4.3 System Programming
Selection
Default
Programming
Conditions
Feature References
VM Command DTMF Set
• LV-MSG / GETMSG / AA-SVC / VM-SVC
• DTMF signal number: 16 digits (max.)
LV-MSG – H; GETMSG –
1. Enter 114.
Display: VM Command Set
2. Press NEXT to program the LV-MSG command.
To program another command, keep pressing NEXT until the desired
command is displayed.
Display example: LV-MSG:H
3. Enter a DTMF signal number.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new number.
4. Press STORE.
5. To program another selection, keep pressing NEXT or PREV
until the desired selection is displayed.
6. Repeat steps 3 through 5.
7. Press END.
• A command signal number can have a maximum of 16 digits,
consisting of 0 through 9,
• The FLASH button is available only for LV-MSG and GETMSG
commands to store "H" which means "Home Position."
• If "H" is stored for "LV-MSG," a mailbox number programmed in
program [609] "Voice Mail Access Codes" or an extension number will
be sent to the VM port (Follow On ID function). If certain codes are
required before and after the ID code, insert "H" between the codes, as
"aaaHbbb." If nothing is stored, it will operate as "H."
• If " H" is stored for "GETMSG," a mailbox number programmed in
program [609] "Voice Mail Access Codes" or an extension number will
be sent to the port succeeding the " ."
Section 3, Features,
Voice Mail Integration
(contd.)
H; AA-SVC – #8 ; VM-SVC – #6
, #, FLASH and PAUSE.
System Programming
114
4-47