Panasonic KX-TD816 Installation Manual page 269

005
Flexible CO Button Assignment
Canceling
Conditions
Feature References
4-24 System Programming
4.2 Manager Programming
4. Press a CO button to be changed.
The display shows the contents pre-assigned to the button.
Display example: CO-01
5. Enter a button code (plus parameter, if required).
To change the parameter, press CLEAR and the new parameter.
6. Press STORE.
7. • To program another CO button of the same jack, repeat
steps 4 through 6.
• To program another jack, press SELECT and repeat steps 3
through 6.
8. Press END.
1. Perform the same procedures as steps 1 through 4 above.
2. Enter 2.
3. Press STORE.
4. Press END.
• A centralized telephone is a telephone connected to jack 01 or a jack
programmed as a manager extension in program [006] "Operator /
Manager Extension Assignment."
• There is a maximum of 16 proprietary telephones for KX-TD816, and
64 proprietary telephones for KX-TD1232.
• In the case of KX-TD1232, jack numbers 01 through 32 are for the
Master System and 33 through 64 are for the Slave, if available. Jack
numbers in the out-of-service system are unacceptable.
• The number of the CO buttons available depends on the telephone type.
(Refer to Section 3 "Buttons on Proprietary Telephones.") To program
24 CO buttons, use the proprietary telephone, KX-T7230.
• If you press the same CO button again at step 5, you can select a desired
ringer frequency for the CO button from eight types of ring tone. When
you enter the tone type number (1 through 8), you will hear the selected
tone type until STORE is pressed. This selection is possible only for
the CO buttons that have been assigned to Single-CO, Group-CO, or
Loop-CO.
Section 3, Features,
Button, Flexible
(contd.)
Buttons on Proprietary Telephones