Panasonic KX-TD816 Installation Manual page 45

2.3.3 Extension Connection
for Proprietary Telephones, Single Line Telephones and DSS Consoles
(KX-TD816: Jack 1 through Jack 8, KX-TD1232: Jack 1 through Jack 16)
Connection of Proprietary Telephones, Single Line Telephones and DSS
Consoles for KX-TD1232
Connection of the Proprietary Telephone, KX-T7130
Connection of a Digital Proprietary Telephone,
KX-T7220, KX-T7230, KX-T7235, or KX-T7250
Connection of an Analog Proprietary Telephone,
KX-T7020, KX-T7030, KX-T7033, KX-T7050 or KX-T7055
Connection of a Single Line Telephone, KX-T7051 or KX-T7052
Connection of a DSS Console, KX-T7040 or KX-T7240
Station Wiring (3-pair twisted cabling):
50-Pin Connector
26 1
1 2
27 3
2 4
28 5
3 6
2-26 Installation
6-conductor wiring is required for each extension.
Connect pins "T", "R", "D1", "D2", "P1" and "P2".
T: Tip
R: Ring
4-conductor wiring is required for each extension.
Connect pins "D1" and "D2" only. ("T" and "R" are only needed if
Section 2.3.4 "Paralleled Telephone Connection," Method 2 is used
for parallel or XDP connection of a DPT and a single line
telephone.)
4-conductor wiring is required for each extension.
Connect pins "T", "R", "D1" and "D2".
2-conductor wiring is required for each extension.
Connect pins "T" and "R".
4-conductor wiring is required for each extension.
Connect pins "D1" and "D2" only. ("T" and "R" are not
necessary.)
Block Terminal
Green
1
Red
2
Black
3
Yellow
4
White
5
Blue
6
Bridging Clips
D1: Data 1 P1: 3 Pair Voice (OHCA)
D2: Data 2 P2: 3 Pair Voice (OHCA)
6
5
4
3
2
1
Line cord