System Programming With Proprietary Telephone - Panasonic KX-TD816 Installation Manual

3 Features
Connection References
Programming References
Feature References
Operation References
S
ystem Programming with Proprietary Telephone
Description
Conditions
*: Available for KX-TD1232 only.
• System administration can be performed on-line except for the
procedures of the diagnosis.
If the system goes off-line, the system functions as if it was in power
failure. (Refer to Power Failure Transfer feature.)
Section 2, Installation,
2.4.6 Remote Card Installation*
Section 4, System Programming,
[107] System Password
[813] Floating Number Assignment
[814] Modem Standard*
Section 3, Features,
System Programming with
Proprietary Telephone
Not applicable.
This system can be programmed with a personal computer or a
proprietary telephone (PT).
Proprietary telephones available for System Programming are:
KX-T7235; KX-T7230; KX-T7130; KX-T7030; KX-T7033
(Display Proprietary Telephones).
Two extensions are allowed to perform System Programming. The
extensions available are:
(1) An extension that is connected to jack 01.
(2) An extension that is assigned as a manager.
For more information and programming instructions, refer to
Section 4, "System Programming."
• During System Programming the system operates normally.
• During System Programming the extension is considered to be busy.
• The display on the PT permits interactive programming.
• Only one access is allowed to System Programming at any one time.
• To access system administration, a valid password must be entered.
The password is factory-programmed and can be changed.
• A personal computer can be used to perform System Programming.
Station Message Detail
Recording (SMDR)
Features
S
3-115