Release Holder Assy - Epson Stylus Office T1110 Service Manual

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
Be careful not to move Compression Spring 4 and the Leaf Spring
C A U T I O N
on the left side of the PF Roller Shaft to the coated section on the
Shaft after removing the PF Roller Shaft.
Compression Spring 4
Leaf spring
Figure 4-140. Handling the PF Roller Shaft
After replacing the PF Roller Shaft, always make the required
A D J U S T M E N T
R E Q U I R E D
adjustments referring to the following.
• "Chapter 5
Adjustment
After replacing the following parts, be sure to apply G-45 grease to the
A D J U S T M E N T
R E Q U I R E D
area specified for each part.
PF Roller Shaft: Chapter 6
6-12 (p.158)
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
(p.128)"
See Figure 6-10 (p.157) - Figure
Disassembling the Printer Mechanism

4.4.16 Release Holder Assy

1. Remove the APG Assy. (p.78)
2. Release the PE Sensor connector cable from the five tabs on the Release Holder
Assy.
3. Remove the three C.B.S. M3 x 6 screws that secure the Release Holder Assy.
4. Remove the three lower tabs of the Release Holder Assy from the Main Frame
with a flathead screwdriver, and remove the Release Holder Assy upwards.
Rear side
3
Release Holder Assy
Front side
Upper Tabs
Figure 4-141. Removing the Release Holder Assy
Align the three upper tabs on the Release Holder Assy with the
positioning holes on the Main Frame.
Tighten the screws in the order shown in
打印机驱动下载 http://www.printerwhy.com/
Revision A
PE Sensor connector cable
Tabs
2 1
2) C.B.S. M3x6
(8±1 kgf.cm)
Lower Tabs
See Figure 4-141 (p.117)
Figure 4-141
Confidential
117