Release Holder Assy - Epson L1800 Service Manual

L1800
Be careful not to move Compression Spring 4 and the Leaf Spring
C A U T I O N
on the left side of the PF Roller Shaft to the coated section on the
Shaft after removing the PF Roller Shaft.
Compression Spring 4
Leaf spring
Figure 3-133. Handling the PF Roller Shaft
After replacing the PF Roller Shaft, always make the required
A D J U S T M E N T
R E Q U I R E D
adjustments referring to the following.
 "Chapter 4
Adjustment
After replacing the following parts, be sure to apply G-45 grease to the
A D J U S T M E N T
R E Q U I R E D
area specified for each part.
 PF Roller Shaft: Chapter 5
5-12 (p.139)
Disassembly And Assembly
(p.109)"
See Figure 5-10 (p.138) - Figure
Disassembling the Printer Mechanism

3.4.16 Release Holder Assy

1. Remove the Lower Housing / Printer Mechanism. (p.61)
2. Remove the ASF Assy. (p.71)
3. Remove the APG Assy. (p.55)
4. Release the PE Sensor connector cable from the five tabs on the Release Holder
Assy.
5. Remove the three C.B.S. M3 x 6 screws that secure the Release Holder Assy.
6. Remove the three lower tabs of the Release Holder Assy from the Main Frame
with a flathead screwdriver, and remove the Release Holder Assy upwards.
Rear side
3
Release Holder Assy
Front side
Upper Tabs
Figure 3-134. Removing the Release Holder Assy
Revision A
PE Sensor connector cable
Tabs
2 1
2) C.B.S. M3x6
(8±1 kgf.cm)
Lower Tabs
Confidential
90