Sensor Check; Check Procedure; Sensor Check List; Sensor Check Screen - Konica Minolta bizhub C450 Service Manual

4. Sensor check

4. Sensor check
4.1

Check procedure

• To allow sensors to be checked for operation easily and safely, data applied to the IC on
the board can be checked on the panel with the main unit in the standby state (including
a misfeed, malfunction, and closure failure condition).
<Procedure>
1. Call the Service Mode to the screen.
☞ For details of how to display the Service Mode screen, see the Adjustment/Setting of
the main unit service manual.
2. Touch the "State Confirmation" key.
3. Touch the "Sensor Check" key.
4.2

Sensor check list

4.2.1

Sensor check screen

• This is only typical screen which may be different from what are shown on each individ-
ual main unit.
4.2.2 Sensor check list
A. Sensor monitor 3
Symbol Panel display
PC1-FN Exit
(Non-sort1)
PC19-FN Exit
(Non-sort3)
PC3-FN Exit
(Finisher)
PC4-FN Upper Paper Pass
PC2-FN Transport Lower
12
Part/Signal name
1st Tray Exit Sensor
Job Tray Exit Sensor
Storage Sensor
Upper Entrance Sensor
Lower Entrance Sensor
Field Service Ver. 1.0 Mar. 2005
4683F3E502DA
Operation characteris-
tics/Panel display
1
Paper Paper not
present
Paper Paper not
present
Paper Paper not
present
Paper Paper not
present
Paper Paper not
present
0
present
present
present
present
present