Field Service Ver. 1.0 Mar. 2005
10.8.5
Original Size Detection
Functions
• To change the document size detection table.
Use
• Use to change the setting for the document size detection table.
Copy Glass : To change the size detection table for the document glass.
ADF
Setting/
<Copy Glass>
Procedure
• The default setting is "Table1."
NOTE
• Table 2 can be set only when Original Size Detection Sensor FD2 is being
mounted.
<ADF>
• The default setting is "Disable."
10.8.6
Foolscap Size Setting
Functions
• To set the size for Foolscap paper.
Use
• Upon setup.
• To change the size for Foolscap paper.
Setting/
• Select the size from among the following five.
Procedure
220 x 330 mm
10.8.7
Initialization
A. Data Clear
Functions
• To initialize the setting data.
Use
• To clears the setting data.
☞
For details on items to be cleared, see page 299 "Contents to be cleared by Reset
function."
NOTE
• When removing or installing the hard disk after registering the data below, be
sure to clear the data.
Referring data: One-Touch Registration, User Authentication/Account Track.
Setting/
1. Call the Service Mode on the screen.
Procedure
2. Select the key as follows.
"System 1" → "Initialization" → "Data clear."
3. Press the Start key.
4. When "OK" is displayed, turn the main power switch OFF, and ON again.
: To set whether or not to detect 18k/16k while using ADF (only when
marketing area is Europe)
"Table1"
Enable
81/2 x 13
81/4 x 13
10. Service Mode
Table2
"Disable"
81/8 x 131/4
8 x 13
261