Management Function Choice - Konica Minolta bizhub C450 Service Manual

Field Service Ver. 1.0 Mar. 2005
12.3.2

Management Function Choice

Functions • To set whether or not the Key Counter, Data Controller, and Vendor are installed.
Use • Use to change the counting method for the administrative units.
Setting/ Key Counter
Procedure • Default setting: Unset
• Select "Color Mode" and "Message" when the Key Counter is mounted.
✽ Color Mode
• If "Mode 1" is selected for "Total Counter"
Mode 1: 1 count per 1 copy cycle
Mode 2: 2 counts per 1 copy cycle
Mode 3: 3 counts per 1 copy cycle
Mode 4: 4 counts per 1 copy cycle
Mode 5: 5 counts per 1 copy cycle
• If "Mode 2" is selected for "Total Counter," "Sizes other than those specified" is
selected for "Size Counter," and the paper used is the specified size or one other than
those specified
Mode 1: 2 counts per 1 copy cycle
Mode 2: 4 counts per 1 copy cycle
Mode 3: 6 counts per 1 copy cycle
Mode 4: 8 counts per 1 copy cycle
Mode 5: 10 counts per 1 copy cycle
• If "Mode 2" is selected for "Total Counter," "Sizes other than those specified" is
selected for "Size Counter," and the paper used is the specified size or one other than
those specified
Mode 1: 1 count per 1 copy cycle
Mode 2: 2 counts per 1 copy cycle
Mode 3: 3 counts per 1 copy cycle
Mode 4: 4 counts per 1 copy cycle
Mode 5: 5 counts per 1 copy cycle
✽ Message
Select the message type when the administrative unit is mounted.
Type 1: Message for Key Counter
Type 2: Message for Card scanning
Type 3: Message for ID management
Type 4: Message for Remote SW
Admin. Unit (Data Controller)
• Default setting: Unset
Vendor
• Default setting: Unset
• Select "Interface" and "Message" when the vendor is mounted.
✽ Interface
Select the interface type when the vendor is mounted.
Type 1: Coin Vendor is set
Type 2: Not used
✽ Message
Select the message type when the vendor is mounted.
Type 1: Message for Coin Vendor
Type 2: Message for Card Keeper
Type 3: Message common to Coin Vendor and Card Keeper
12. Billing Setting
297