Adjustment Of The Center Stapling Position - Konica Minolta bizhub C450 Service Manual

Hide thumbs Also See for bizhub C450:
Table of Contents

Advertisement

6. Board switch
6.1.2

Adjustment of the center stapling position

• When a stapling position is adjusted, adjust the stapling position to the folding position.
Make this adjustment after replacing the Finisher Control Board or when the stapling
position must be changed for some reason.
NOTE
• Depending on the type of paper, both the folding position and the stapling position
may be inaccurate. In this case, make adjustment independently from the Finisher.
In this independent adjustment from the Finisher, set the adjustment value of
"Center Stapling Position" and "Folding Position" in the service mode to ± 0mm
on the main unit.
ON
1
2
3
4
- direction
- direction
3. After setting the adjustment value of the stapling position, set all bits of SW1 on the Fin-
isher Control Board to OFF.
4. Perform the "Booklet Creation" on the main unit, and confirm that the stapling position
has been correctly adjusted. If not, redo the adjustment.
42
5
6
7
8
4583fs3512c0
+ direction
+ direction
4583fs3523e0
Field Service Ver. 1.0 Mar. 2005
1. Set SW1 on the Finisher Control
Board as shown on the Left figure.
2. Press PSW1 or PSW2 on the Fin-
isher Control Board for the required
times to adjust the stapling position.
One pressing of the switch moves
the stapling position by approx. 0.14
mm.
• Press PSW1 to move the stapling
position in the "-" direction.
• Press PSW2 to move the stapling
position in the "+" direction.
• Press PSW1 and PSW2 simulta-
neously to clear the present set adjust-
ment value.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents