BCM50 System Start Up
Physical Connection to the BCM
The BCM50 OAM port can accommodate either a patch cable or a cross-over
cable.
One end of the cable is connected to the PC network card, the other end to
the OAM port of the BCM.
Testing the IP connection using Ping
When a physical connection has been made, you should next test the
connection by "pinging" the BCM. This test is performed on the Laptop/PC
that is connected to the BCM.
1. Go to the Start button on your Windows desktop, and select Run.
2. Type command and press OK. This will bring up the MS-DOS /
command prompt.
12
NN40010-318 Issue 1.2 BCM50 Rls 6.0