Inspection; Left Mount; Removal; Installation - Chrysler Concorde 2004 Service Manual

Hide thumbs Also See for Concorde 2004:

Table of Contents

ENGINE MOUNTING (Continued)

INSPECTION

Engine hydro-mounts may show surface cracks.

This will not effect performance and mount should

not be replaced. Only replace the engine hydro-

mounts when leaking fluid.

(1) Raise vehicle on hoist.

(2) Remove the isolator attaching nuts from top of

the mounting bracket (Fig. 98).

(3) Support the engine with a jack and a block of

wood across the full width of the oil pan.

(4) Remove the lower attaching nuts from the bot-

tom of the isolator to the frame (Fig. 98).

(5) Raise engine carefully with jack enough to

remove the isolator with heat shield from its mount.

2 - REAR ISOLATOR

5 - ISOLATOR

(1) Install isolator mount with heat shield onto the

(2) Lower the engine onto the isolator mount.

(3) Remove jack from vehicle.

(4) Tighten the isolator to frame nuts to 61 N·m

(45 ft. lbs.) (Fig. 98).

(5) Install the upper attaching nuts to mount and

tighten to 61 N·m (45 ft. lbs.) (Fig. 98).

(6) Lower vehicle.

Fig. 98 ENGINE MOUNTING

6 - HEAT SHIELD

8 - ENGINE MOUNT BRACKET

Table of Contents

300m 2004 Intrepid 2004