Chrysler 1998 Voyager Service Manual page 1561

NS
REMOVAL AND INSTALLATION (Continued)
Fig. 22 Input (Turbine) Speed Sensor
Fig. 23 Output Speed Sensor
TRANSMISSION CONTROL MODULE
Do not interchange Transmission Control Modules
with previous year transmission control modules. If a
same year TCM is being used from a different vehi-
cle, the following procedures must be performed:
• Quick Learn Procedure
• Electronic Pinion Procedure
The Transmission Control Module is located on the
right fender inner panel, in the engine compartment.
It is held in place by four mounting screws.
NOTE: If the Transmission Control Module has
been replaced, the following procedures must be
performed:
• Quick Learn Procedure: This procedure will
allow the transmission control module to learn the
characteristics of the vehicle.
TRANSAXLE AND POWER TRANSFER UNIT
• Electronic Pinion Factor Procedure: This proce-
dure will reprogram the TCM to compensate for dif-
ferent tire sizes and final drive ratios.
REMOVAL
(1) Loosen 60 way retaining screw, located in the
center of the 60 way connector (Fig. 24). Then discon-
nect the 60 way connector on Transmission Control
Module.
Fig. 24 Loosen Connector Screw
(2) Remove Transmission Control Module mount-
ing screws and lift module from vehicle (Fig. 25) (Fig.
26).
Fig. 25 Mounting Screws
INSTALLATION
(1) To install, reverse removal procedure.
21 - 87