Chrysler 1998 Voyager Service Manual page 1801

NS
REMOVAL AND INSTALLATION (Continued)
Fig. 115 Latch/Lock Control Link Removal
SLIDING DOOR LOWER ROLLER ARM
REMOVAL
(1) Open sliding door.
(2) Mark outline of roller arm on sliding door
bracket to aid installation.
(3) Remove sliding door sill plate.
(4) Remove screws holding hold open latch to
lower roller arm.
(5) Separate hold open latch from lower arm.
Fig. 114 Sliding Door Latch/Lock Control Linkage
(6) Support sliding door on a suitable lifting device
with a padded upper surface. The door must be
moveable with lifting device in place.
(7) Remove bolts holding lower roller arm to slid-
ing door (Fig. 116).
(8) Remove roller arm from sliding door.
(9) Disengage roller arm from lower channel (Fig.
117).
(10) Remove roller arm from vehicle.
INSTALLATION
For installation, reverse the above procedures.
SLIDING DOOR LOWER ROLLER ARM BRACKET
REMOVAL
(1) Remove access hole plug.
(2) Open sliding door.
(3) Support sliding door on a suitable lifting
device.
(4) Remove lower roller arm.
(5) Mark outline of roller arm bracket on inside of
sliding door.
(6) Remove bolts holding lower roller arm bracket
to sliding door (Fig. 118).
(7) Remove lower roller bracket from vehicle.
BODY 23 - 71