Chrysler 1998 Voyager Service Manual page 1902

24 - 36 HEATING AND AIR CONDITIONING
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 76 Blend-Air Door
(24) Remove separator plate from distribution
housing (Fig. 77).
Fig. 77 Separator Plate
(25) Remove lower half of the blend-air door (Fig.
78).
Fig. 78 Lower Blend-Air Door
(26) Remove lower half of the Panel door (Fig. 79).
Fig. 79 Lower Panel Door
(27) Remove lower half of the Floor door (Fig. 80).
Fig. 80 Lower Floor Door
ASSEMBLY—DISTRIBUTION HOUSING
For reassembly of the distribution housing, reverse
the above procedures.
To reassemble the distribution housing actuator
gears an assembly procedure of the gears and cam is
necessary.
ACTUATOR GEARS ALIGNMENT PROCEDURE
(1) Install lower FLOOR door actuator gear to
housing. Match master spline of FLOOR door actua-
tor gear to master spline on door.
(2) Install cam wheel. Align cam wheel track to
FLOOR door actuator gear.
(3) Align cam wheel slot with the post on the dis-
tribution housing marked "1".
NS/GS