Chrysler 1998 Voyager Service Manual page 1671

NS/GS
REMOVAL AND INSTALLATION (Continued)
Fig. 40 Front Engine Mount (Left Side)
Fig. 41 Front Engine Mount (Right Side)
Fig. 42 Left Mount Bolts
(4) Check the transaxle for leaks and recheck the
level of the transaxle lubricant.
A–598 MANUAL TRANSAXLE
INPUT SHAFT FRONT BEARING RETAINER
REMOVAL
(1) Remove the transaxle assembly from the vehi-
cle. For removal procedure, refer to Transaxle,
Removal and Installation.
(2) From inside the bellhousing, remove the E-clip
retaining the clutch release lever shaft (Fig. 43).
Fig. 43 E-clip at Clutch Release Lever Shaft
(3) Pull release lever shaft out of the clutch bell-
housing (Fig. 44).
Fig. 44 Clutch Release Shaft
(4) Remove the clutch release bearing from the
input bearing retainer sleeve (Fig. 45).
(5) Remove the three bolts retaining the input
shaft bearing retainer sleeve (Fig. 46).
(6) Remove the input bearing retainer sleeve from
the front of the bellhousing.
INSTALLATION
(1) For installation, reverse removal procedure.
Use Mopar Gasket Maker to seal input bearing
retainer sleeve to bellhousing.
21 - 15