NS
REMOVAL AND INSTALLATION (Continued)
Fig. 36 Seal Removal
Fig. 37 Seal Installation
Fig. 38 Bearing Shim and Race
CAUTION: When end cover is installed be careful
not to damage the P.T.U. Input Shaft Cover Seal.
(6) Reinstall P.T.U. assembly into vehicle.
TRANSAXLE AND POWER TRANSFER UNIT
Fig. 39 Installing Bearing Race
Fig. 40 Bolt Tightening Sequence
(7) Check and fill fluids as required.
HALF SHAFT INNER SEAL
The power transfer unit half shaft inner seal is the
smaller of the two seals located on the inside of the
end cover.
REMOVAL
(1) Remove power transfer unit from the vehicle.
(2) Remove end cover bolts (Fig. 41).
(3) Tap on end cover ears to separate cover from
case (Fig. 42).
(4) Drive seal out with a hammer and small chisel
(Fig. 43).
21 - 175