Chrysler 1998 Voyager Service Manual page 1075

NS
REMOVAL AND INSTALLATION (Continued)
Fig. 24 Engine Mounting—Right Side
ENGINE MOUNT—REAR
REMOVAL
(1) Raise vehicle on hoist and remove the left
front wheel.
(2) Support the transaxle with a jack so it will not
rotate.
(3) Remove the insulator thru bolt from the
mount and rear suspension crossmember.
(4) Remove the four mount fasteners and remove
the mount.
INSTALLATION
(1) Reverse the removal procedure for installation.
Refer to (Fig. 25).
Fig. 25 Engine Mounting—Rear
STRUCTURAL COLLAR
REMOVAL
(1) Raise vehicle on hoist.
(2) Remove front engine mounting bracket from
bending strut and front insulator mount.
(3) Remove bolts attaching bending strut to engine
and transaxle.
(4) Remove bolts attaching collar and strut to
engine, oil pan, and transaxle. Remove strut and col-
lar.
Fig. 26 Structural Collar and Bending Strut—
Removal and Installation
INSTALLATION
CAUTION: Torque procedure for the structural col-
lar and bending strut must be followed or damage
could occur to oil pan, collar, and/or bending strut.
(1) Perform the following steps for installing struc-
tural collar and bending strut. Refer to (Fig. 26):
• Step 1: Place collar into position between tran-
saxle and oil pan. Hand start only, collar to transaxle
bolt 1.
• Step 2: Install bolt 4, collar to oil pan, hand
tight only.
• Step 3: Position bending strut in place and hand
start bolt 3 into the upper transaxle hole.
• Step 4: Install bolt 2, through strut and collar.
Hand starting only.
• Step 5: Install bolt 6, strut to cylinder block,
hand tight only.
• Step 6: Install the remaining collar to oil pan
bolt 5, hand tight only.
• Step 7: Final torque collar to transaxle bolts 1 –
3, to 101 N·m (75 ft. lbs.)
• Step 8: Install bolts 7 and 8, through strut and
into cylinder block.
• Step 9: Final torque bolts 4 – 8 to 61 N·m (45 ft.
lbs.).
(2) Lower vehicle.
2.4L ENGINE 9 - 25