Chrysler 1998 Voyager Service Manual page 1244

9 - 66 ENGINE
REMOVAL AND INSTALLATION (Continued)
Fig. 45 Main Bearing Carrier Alignment
Fig. 46 Measuring Crankshaft End Play
CAUTION: The vacuum pump must be centered in
the block and tighten with two bolts. Ensure that
the pump spins freely. If vacuum pump drags or
does not spin freely loosen bolts and perform pro-
cedures again.
(28) Before installing oil pump check pump bore
depth in block (A) and pump body height (B) (Fig.
47). Difference between A and
0.020-0.082 mm (.0007 to 0032 in.).
Fig. 47 Oil Pump Bore Depth
(29) Install oil pump and tighten retaining screws
to 27 N·m (20 ft. lbs.). Check for normal backlash
between pump and crankshaft gears.
(30) Install oil pump drive Gear.
(31) Install front cover. Refer to procedure in this
section.
(32) Install vibration damper. Refer to procedure
in this section.
(33) Install cylinder heads. Refer to procedure in
this section.
(34) Install rocker arms and push rods. Refer to
procedure in this section.
(35) Install cylinder head cover. Refer to procedure
in this section.
(36) Install accessary drive system.
(37) Install engine in vehicle. Refer to procedure in
this section.
(38) Fill engine with the correct amount of fluids
specified.
(39) Connect battery cable.
OIL PAN
REMOVAL
(1) Disconnect battery cable.
(2) Raise vehicle on hoist.
NS/GS
B should be