Chrysler 1998 Voyager Service Manual page 1740

23 - 10 BODY
REMOVAL AND INSTALLATION (Continued)
Fig. 2 Bench Seat Back Cover
(4) Remove seat back hinge from seat.
(5) Disengage synchronizing cable housing from
seat back hinge.
(6) Disengage synchronizing cable end from (clip
on left side) hinge latch release arm.
(7) Remove hinge from seat.
INSTALLATION
(1) Place hinge in position on seat.
(2) Engage synchronizing cable end into (clip on
left side) hinge latch release arm.
(3) Engage synchronizing cable housing into seat
back hinge.
(4) Place seat back hinge in position on seat.
(5) Install bolts to hold seat back hinge to seat
cushion frame.
(6) Install shoulder bolts to hold seat back hinge to
seat back frame (Fig. 3).
(7) Install bench seat back hinge covers.
(8) Verify seat back hinge operation.
SYNCHRONIZING CABLE ADJUSTMENT
If the seat back hinges do not release at the same
time the synchronizing cable must be adjusted.
(1) Remove seat from vehicle. Refer to Owner's
Manual for proper procedures (Fig. 4).
(2) Using a awl, pry synchronizing cable end from
clip on left seat back hinge.
(3) Pull cable out of housing until cable is tight.
(4) Push retaining clip on hinge latch release arm
rearward to take up play in hinge mechanism.
(5) Engage cable end into retaining clip on hinge.
BENCH SEAT BACK HINGE COVERS
REMOVAL
(1) If necessary, remove seat from vehicle. Refer to
Owner's Manual for proper procedures.
Fig. 3 Bench Seat Back Hinge
Fig. 4 SYNCHRONIZING CABLE ADJUSTMENT
(2) Remove screws holding lower cover to seat
back hinge (Fig. 5).
(3) Remove lower cover from hinge.
(4) Remove screws holding upper hinge cover to
seat back hinge.
(5) Remove upper cover from seat back hinge.
INSTALLATION
(1) Place upper cover in position on seat back
hinge.
(2) Install screws to hold upper hinge cover to seat
back hinge.
(3) Place lower cover in position on hinge.
(4) Install screws to hold lower cover to seat back
hinge (Fig. 5).
(5) If necessary, install seat in vehicle.
NS