Chrysler 1998 Voyager Service Manual page 1795

NS
REMOVAL AND INSTALLATION (Continued)
REMOVAL
(1) Apply masking tape to outside surface of quar-
ter panel below the center roller channel, rearward of
the door opening.
(2) Release sliding door latch and open door.
(3) Apply masking tape to door jamb area, rear-
ward of the upper roller channel.
(4) Remove screw holding upper roller arm stop
bumper to upper roller arm (Fig. 97).
(5) Remove stop bumper from upper roller arm.
(6) Remove center stop bumper trim cover from
sliding door (Fig. 98).
(7) Remove center stop from sliding door.
(8) Remove sliding door sill plate.
(9) Remove hold open latch striker (Fig. 99).
(10) Open quarter glass.
(11) Remove center roller channel end cover (Fig.
100).
(12) Support sliding door on a suitable lifting
device with a padded upper surface. The door must
be moveable with lifting device in place.
CAUTION: Do not allow the center hinge roller to
contact the quarter glass. Glass can break.
(13) Roll door rearward until lower rollers disen-
gage from lower channel.
(14) Roll the door rearward until the upper (Fig.
101) and center hinge rollers exit the upper and cen-
ter channels (Fig. 102).
(15) Remove sliding door from vehicle.
Fig. 97 Sliding Door Upper Stop
INSTALLATION
(1) Place sliding door in position on lifting device.
(2) Position door rearward of the sliding door open-
ing.
CAUTION: Do not allow the center hinge roller to
contact the quarter glass. Glass can break.
Fig. 98 Sliding Door Center Stop Bumper
Fig. 99 Sliding Door Hold Open Latch Striker
Fig. 100 Center Channel End Cover
(3) Engage the center hinge rollers into the center
channels (Fig. 102).
(4) Roll door forward until lower rollers engage
into rear of lower channel.
(5) Engage the upper hinge into the upper chan-
nels (Fig. 101).
(6) Install hold open latch striker (Fig. 99).
(7) Install sliding door sill plate.
BODY 23 - 65