Chrysler 1998 Voyager Service Manual page 1599

NS
DISASSEMBLY AND ASSEMBLY (Continued)
Fig. 221 Install Rear Carrier Assembly
Fig. 222 Install Output Gear Bearing Cone
OUTPUT GEAR BEARING ADJUSTMENT
(1) With output gear removed: install a 4.50 mm
(0.177 inch) gauging shim on the rear carrier assem-
bly hub, using grease to hold the shim in place.
(2) Using Tool 6259, install output gear and bear-
ing assembly. Torque to 271 N·m (200 ft. lbs.).
To measure bearing end play:
TRANSAXLE AND POWER TRANSFER UNIT
(3) Attach Tool L-4432 to the gear.
(4) Push and pull the gear while rotating back and
forth to insure seating of the bearing rollers.
Fig. 223 Checking Output Gear Bearings End Play
(5) Using a dial indicator, mounted to the tran-
saxle case, measure output gear end play (Fig. 223).
21 - 125