Chrysler 1998 Voyager Service Manual page 1701

NS/GS
DISASSEMBLY AND ASSEMBLY (Continued)
(3) Install the synchro springs into the synchro
struts.
(4) Line up stop ring tang over the struts in the
hub. Install stop rings. Center the struts by pushing
on both stop rings.
(5) Install the outer cones (dual-cone synchronizer)
into the synchronizer stop rings.
(6) Install the inner cones (dual-cone synchronizer)
into the outer cones.
SHIFT COVER
The gearshift cover can be disassembled and worn
parts can be replaced individually (Fig. 178).
DISASSEMBLY
(1) Remove gearshift housing roll pin at shift lever
(Fig. 179).
(2) Remove shift selector shaft dust boot (Fig. 180).
(3) Remove selector shaft oil seal (Fig. 181).
(4) Remove shifter housing vent cap at crossover
lever (Fig. 182).
Fig. 178 Gearshift Housing-Exploded View
A–598 MANUAL TRANSAXLE
Fig. 179 Shift Lever Roll Pin
(5) Remove roll pin and crossover lever at cross-
over shaft (Fig. 183).
(6) Remove the 5th/reverse gear blocker (Fig. 184).
(7) Remove the crossover shaft (Fig. 185).
21 - 45