Chrysler 1998 Voyager Service Manual page 1269

NS
REMOVAL AND INSTALLATION (Continued)
Fig. 13 Fuel Line Quick Disconnect
(5) Drain cooling system. Refer to Group 7, Cool-
ing System for procedure.
(6) Remove heater, and upper radiator hoses at
intake manifold.
(7) Disconnect coolant temperature sensor (Fig.
14).
(8) Remove the accessory drive belt. Refer to
Accessory Drive belt Removal and Installation in
Group 7, Cooling System for procedure.
(9) Remove fasteners attaching generator bracket
to cylinder head, and block.
Fig. 14 Coolant Temperature Sensor—2.4L
(10) Remove intake
bracket bolts (Y bracket) (Fig. 15)
(11) Disconnect fuel injector harness.
manifold center support
EXHAUST SYSTEM AND INTAKE MANIFOLD
Fig. 15 Intake Manifold Center Support Bracket
(12) Remove lower intake manifold fasteners (Fig.
16). Remove the manifold from engine.
Fig. 16 Intake Manifold Fasteners
(13) Inspect and clean manifold. Refer to Cleaning
and Inspection outlined in this section for proce-
dures.
INSTALLATION
If the following items were removed, install and
torque to:
• Fuel Rail Bolts 22 N·m (200 in. lbs.)
• Engine Outlet Connector Bolts 28 N·m (250 in.
lbs.)
• Coolant Temperature Sensor 7 N·m (60 in. lbs.)
• Intake Air Temperature Sensor 28 N·m (250 in.
lbs.)
(1) Using a new intake gasket, position intake
manifold on the engine and install retaining bolts.
11 - 7