Chrysler 1998 Voyager Service Manual page 1712

21 - 56 A–598 MANUAL TRANSAXLE
ADJUSTMENTS (Continued)
Fig. 220 Lock Pin Installation
Fig. 221 Gearshift Knob
(10) Tighten crossover cable adjuster to 8 N·m (70
in. lbs.) (Fig. 224).
CAUTION: Proper torque to the crossover cable
adjusting screw is very important.
(11) Remove lock pin from gearshift housing. Rein-
stall auxiliary vent in gear shift housing (Fig. 225).
Tighten auxiliary vent to 8 N·m (70 in. lbs.).
(12) Check for shift into first and reverse.
(13) Gearshift mechanism and cables are now
functioning properly.
(14) Install gearshift console.
(15) Install gearshift boot.
(16) Install gearshift knob.
Fig. 222 Gearshift Boot
Fig. 223 Gearshift Console
(17) Stow gearshift lock pin in glove packet.
BEARING ADJUSTMENT PROCEDURE
The A-598 (T-750) transaxle has two bearing
adjustment procedures that must be performed if the
transaxle case or related components have been
replaced. If the intermediate shaft, and/or bearing
cups and cones have been replaced, you must per-
form the intermediate shaft preload shim adjust-
ment. If the differential case, cups or cones have
NS/GS