Chrysler 1998 Voyager Service Manual page 1424

14 - 56 FUEL SYSTEM—2.5L DIESEL ENGINE/2.0L GAS ENGINE
REMOVAL AND INSTALLATION (Continued)
Fig. 24 Vehicle Speed Sensor Location—Typical
REMOVAL
(1) Raise and support vehicle.
(2) Clean the area around the sensor before
removal.
(3) Disconnect the electrical connector from the
sensor (Fig. 25).
(4) Remove the sensor mounting bolt (Fig. 25).
(5) Pull the sensor from the speedometer pinion
gear adapter for removal.
INSTALLATION
(1) Install new sensor into speedometer gear
adapter.
Fig. 25 Sensor Removal/Installation—Typical
(2) Tighten sensor mounting bolt. To prevent dam-
age to sensor or speedometer adapter, be sure the
sensor is mounted flush to the adapter before tight-
ening.
(3) Connect electrical connector to sensor.
SPECIFICATIONS
GLOW PLUG CURRENT DRAW
Initial Current Draw: Approximately 22–25
amps per plug.
After 20 seconds of operation: Approximately
9–12 amps per plug.
NS/GS